An auto clicker needs to know where to send input. Two common choices are the pointer’s current location and a saved screen coordinate. Both are useful, but they fail in different ways.
Choose the position mode before tuning speed or repeat count.
Current-cursor mode
Current-cursor mode uses the pointer location when the run begins or clicks wherever the cursor is kept, depending on the app’s control. It is useful when you want to aim manually.
Good uses include:
- Repeating a click on a target you can see.
- Moving between tasks without saving a new point.
- A short supervised run.
- A target whose location changes between sessions but stays still during the run.
The main risk is accidental pointer movement. If you bump the mouse, switch windows, or place the pointer over a different control before pressing the hotkey, clicks may go elsewhere.
Fixed-position mode
A fixed position stores an x/y screen coordinate. It is useful when the target remains in the same place and the sequence should be repeatable.
Good uses include:
- A stable desktop test layout.
- Several saved click points.
- A window that is always opened at the same size and position.
- A controlled kiosk or lab setup.
The risk is layout drift. The saved coordinate remains the same even if the window, display, or target moves.
Compare the two modes
| Question | Current cursor | Fixed position |
|---|---|---|
| Do you aim manually before starting? | Yes | No |
| Can you reuse a saved coordinate? | No | Yes |
| Best for several points? | No | Yes |
| Sensitive to mouse movement? | High | Low |
| Sensitive to moved windows or scaling? | Medium | High |
| Best for a short supervised task? | Yes | Yes |
| Best for a repeatable test layout? | Limited | Yes |
Neither mode recognizes buttons by name. They both operate on screen position.
How fixed coordinates become inaccurate
Capture points again after:
- Moving or resizing the target window.
- Changing resolution.
- Changing Windows display scaling.
- Reordering monitors.
- Connecting through remote desktop.
- Changing browser zoom.
- A website or app redesign.
If every saved point is offset by a similar amount, a display or window change is more likely than a clicker timing problem.
Use the focused guide for an auto clicker clicking the wrong location to diagnose it.
A safe current-cursor test
- Choose left single-click.
- Set a 500 ms interval.
- Set 10 repetitions.
- Place the pointer in the center of a harmless test button.
- Press the start hotkey without touching the mouse.
- Press the stop hotkey before moving to another control.
Do not use current-cursor mode with a long unattended run. An ordinary mouse movement can redirect every later click.
A safe fixed-position test
- Place and size the target window.
- Capture the center of one harmless target.
- Set a 1000 ms interval and one repetition.
- Start the run while watching.
- Add later points only after the first is correct.
- Save the configuration with its required display scale.
For several points, follow the multi-point auto clicker tutorial.
Which mode should you choose?
Use current cursor when the operator will aim and supervise each run. Use fixed position when the environment is controlled and reproducibility matters.
If the target location changes while the workflow runs, neither raw position mode is ideal. Use a supported automation feature that identifies interface elements, or keep that step manual.
Frequently asked questions
Does fixed position move the pointer?
Behavior can vary by automation mode, but the important part is that input is sent to a saved coordinate. Test the visible result before relying on it.
Can I save a position on a second monitor?
Yes, but monitor order and scaling must remain stable. Recheck after reconnecting a display.
Is current cursor safer?
It is easier to aim but easier to redirect accidentally. Fixed points are more repeatable but more vulnerable to layout changes. Safety depends on the workflow.
Bottom line
Current cursor is flexible; fixed position is reproducible. Use a short fixed count, keep the stop hotkey ready, and never assume coordinates understand what appears underneath them.
