An auto clicker needs two separate timing decisions: how fast to click and when to stop. The interval answers the first question. Repeat count, duration, and continuous mode answer the second.
A defined endpoint makes a new automation easier to test and much less likely to continue on the wrong screen.
Fixed repeat count
A fixed count stops after a set number of clicks or cycles. It is the best default for:
- A first configuration test.
- A task with a known quantity.
- Comparing expected actions with completed results.
- A workflow that must never run indefinitely.
Start with 10 clicks. If the target reports 10 completed actions, you can increase the count with more confidence.
Be clear whether the app counts individual clicks, double-click events, points, or full point cycles. Run a tiny test to observe the actual behavior.
Duration mode
Duration mode keeps running until a timer expires. It fits a proven task that should operate for a specific period.
Use it when:
- The exact number of clicks does not matter.
- The process has been tested at the selected interval.
- The screen remains stable for the whole period.
- A time limit is safer than leaving the task open-ended.
Begin with 30 seconds, then inspect the result. Do not jump directly to hours.
Continuous mode
Continuous or infinite mode runs until the stop control is used. It is convenient, but it has no automatic safety boundary.
Use it only when:
- The stop hotkey has been tested.
- The target can remain safely active.
- A person is supervising the run.
- No destructive or financial action lies under the pointer.
- You accept that a dialog or layout change can redirect later clicks.
A continuous run is not automatically better for a long task. A generous duration still provides a fallback stop.
Estimate the number of clicks
For a single point:
Expected clicks = duration in seconds × approximate CPS
At a 500 ms interval, the approximate speed is 2 CPS. A 30-second duration requests about 60 clicks.
For multi-point mode, clarify whether one interval applies between points and whether the repeat setting counts clicks or cycles. Observe a one-cycle test rather than relying on an assumption.
Use the auto clicker interval guide for the conversion table.
Which mode is best?
| Situation | Recommended stop mode |
|---|---|
| First-ever test | 10-click fixed count |
| Exactly 25 records | Fixed count, with human verification |
| Run a safe local test for 60 seconds | Duration |
| Demo while a presenter watches | Fixed count or duration |
| Long unattended task | Redesign with checkpoints; avoid continuous |
| Unknown target behavior | One click |
A known quantity favors count. A known time favors duration. Uncertainty favors the smallest possible test.
Repeat settings with multiple points
Suppose a sequence contains four points. “Repeat five times” might mean five complete cycles or a certain number of individual actions, depending on the mode. Verify by running one repetition and observing all four points.
The sequence must return to the same safe state before another cycle begins. See the multi-point setup guide before raising the repeat value.
Build a safe escalation path
For any new task:
- Run one action.
- Run 10 actions or one complete cycle.
- Run for 30 seconds.
- Review the result.
- Increase count or duration gradually.
- Use continuous mode only if a defined endpoint truly cannot express the task.
At every stage, press the stop hotkey once to confirm it responds.
Frequently asked questions
Does the repeat count include a double click as one or two?
The interface may count a double-click event as one repetition even though it sends a pair. Test with one repetition and inspect the target.
What happens when the duration ends mid-sequence?
Behavior depends on the mode. Use a short test to confirm whether it completes the current action or stops immediately.
Is a two-hour duration safe?
Only if shorter tests prove the screen and target remain stable, and the task is permitted. A longer timer does not make coordinate automation more aware of unexpected changes.
Bottom line
Use count to learn, duration to limit a proven run, and continuous mode sparingly. A predictable stop is part of correct automation, not an optional extra.
